Do not exceed 15 seconds.
2010 dodge ram 1500 key fob reset.
You should hear it unlock.
Turn on ignition switch to on position engine off repeatedly press vechicle information button until press to relearn remote key is displayed press set reset button until remote key learning active is displayed.
Remove metal key from fob.
Apr 2 2018 at 8 30 am 3.
Pry the two sections apart.
Press the lock button on the remote with your left hand.
Insert new cr2032 battery.
Press and release the button five times within ten seconds.
Turn ignition switch to off and remove key.
Insert a flat edged tool like a screwdriver into the gap.
Step 1 sit in your car with your remote and your key fob.
Step 2 insert your dodge ram 1500 key into your car s ignition and click the key to the on position.
Gently remove dead ram key fob battery.
But i did read a post awhile ago that said it is now possible but haven t verified it as true.
Save your self some cash.
Click unlock on the fob that s in the ignition.
Easy peasy repair and replace no programming needed if circuit board is not damaged.
Turn ignition to the off position and remove key.
Now put the key fob into ignition and turn to on position.
Snap the two halves of your dodge ram key fob battery back together.
Insert the first working fobik remote key into ignition.
You would have to check with a dealership or a local locksmith to see if it is possible.
Hold the lock on the fob for 5 sec.
You must do this within 15 seconds of removing first key.
Take the following steps to replace your chrysler dodge jeep or ram key fob battery.
Turn vehicle off and turn hazards off unless you want to drain your battery.
Procedure 2 ram 1500 fobik remotes step by step how to programming instructions.
Enter your dodge ram 1500 and close the doors and trunk of your vehicle.
Turn ignition to the on position for at least three 3 to fifteen 15 seconds.