Service type clutch pedal goes all the way to the floor inspection.
2013 nissan altima 2 5 brake pedal goes to the floor.
Service type clutch pedal goes all the way to the floor inspection.
2005 nissan altima l4 2 5l.
Two mechanics have tried new master cylinders but pedal still goes low they suspect abs module but the abs light never came on.
And nissan dealer says nothing is wrong or the brake light would be on.
Shop dealer price 95 61 103 57.
The leak may coming from a brake line or one of the brake calipers.
Check the brake fluid level.
Using a flashlight check the level of the fluid or just remove the lid of the reservoir and look inside.
Brake light comes up randomly while driving at local or highway speed.
My 2013 nissan altima 3 5 sl start surging going faster than the speed limit.
I bled the brakes and the master cylinder at least 10 times.
Transmission is making grinding noise.
The car will still stop unless you have to stop quickly.
1 leak from brake line or brake caliper.
If the fluid is full then continue onto brake fluid is full down further in this guide.
One of the reasons is the brake system loses pressure from an external brake fluid leak.
Shop dealer price 100 24 107 93.
Reasons your brake pedal goes to the floor.
Problem with your 2013 nissan altima.
Replaced the master cylinder.
Hood pop up while driving issue with latch 3.
Anytime you have a brake pedal that goes to the floor raise the hood and locate the brake master cylinder s reservoir.
2010 nissan altima l4 2 5l hybrid.
Brake light is not on.
Technically there are two main causes that would make the brake pedal sink all the way to the floor.
Brake pedal was going clear to the floor.
I applied on brakes pushing them down to the floor my car hit a 2013 durango suv on the driver side knocking the rear.
I have a nice firm brake pedal when the car is not running as soon as i start the engine the pedal goes almost to floor.
Three major issues has been occuring with my 2013 nissan altima 2.
Now pedal will go to the floor and is much lower than before the job.
So i ruled out the master cylinder since i just replaced it last week.
I have a 2001 nissan maxima se rear calipers were locking up had two new loaded calipers and rotors put on rear.
2013 nissan altima v6 3 5l.